kumquat-buildroot

NetCube-Systems-Austria/kumquat-buildroot

History

Jagan Teki 82d882eef0 board: amarula: vyasa: Give raw space for falcon mode RK3288 Vyasa board support falcon mode in U-Boot and SD layout start from 16MB offset for args and 17MB for uImage. So give full u-boot partition space as 30M so-that it can occupy bigger uImage file and doesn't overlap rootfs partition. [Peter: use # as comment character, clarify comment wording] Reported-by: Shyam Saini <shyam@amarulasolutions.com> Tested-by: Shyam Saini <shyam@amarulasolutions.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> Signed-off-by: Shyam saini <shyam@amarulasolutions.com> Signed-off-by: Peter Korsgaard <peter@korsgaard.com>		2018-05-27 22:05:35 +02:00
..
extlinux.conf	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00
genimage.cfg	board: amarula: vyasa: Give raw space for falcon mode	2018-05-27 22:05:35 +02:00
linux_gmac.fragment	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00
post-build.sh	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00
readme.txt	board: Add Vyasa RK3288 board support	2018-02-06 11:39:48 +01:00

readme.txt

Vyasa RK3288
============

Vyasa is RK3288 based Single board computer with fully supported opensource software.

https://openedev.amarulasolutions.com/display/ODWIKI/Vyasa+RK3288

How to build it
===============

  $ make amarula_vyasa_rk3288_defconfig

Then you can edit the build options using

  $ make menuconfig

Compile all and build rootfs image:

  $ make

Prepare your SDCard
===================

Buildroot generates a ready-to-use SD card image that you can flash directly to
the card. The image will be in output/images/sdcard.img.
You can write this image directly to an SD card device (i.e. /dev/xxx):

  $ sudo dd if=output/images/sdcard.img of=/dev/xxx
  $ sudo sync

Finally, you can insert the SD card to the Vyasa RK3288 board, close J4 and boot it.