b73f5c32af
This patch adds support for Xilinx Kria KV260 starter kit. KV260 features can be found here: https://www.xilinx.com/products/boards-and-kits/kv260.html While the Kria SOM is based on a ZynqMP SoC, there are some key boot config differences from the other ZynqMP evaluation boards. 1. There are no boot switches on Kria SOMs. The boot mode is thus hard configured for QSPI flash. A pre-programmed boot.bin comes with every Starter Kit. U-Boot can then find the Linux kernel and file system on the SD card. Optional instructions for updating the boot.bin in the QSPI flash can be found in the readme.txt file and the link below. https://xilinx-wiki.atlassian.net/wiki/spaces/A/pages/1641152513/Kria+K26+SOM 2. Kria SOMs use UART1 for the console instead of UART0. For this reason, Kria Starter Kits will use a separate extlinux.conf file from other ZynqMP evaluation boards. Signed-off-by: Neal Frager <neal.frager@amd.com> Signed-off-by: Peter Korsgaard <peter@korsgaard.com>
9 lines
186 B
Bash
Executable File
9 lines
186 B
Bash
Executable File
#!/bin/sh
|
|
|
|
# genimage will need to find the extlinux.conf
|
|
# in the binaries directory
|
|
|
|
BOARD_DIR="$(dirname $0)"
|
|
|
|
install -m 0644 -D $BOARD_DIR/extlinux.conf $BINARIES_DIR/extlinux.conf
|