7b02ca842d
Add support for PineCube with: - U-Boot 2022.04 - Linux 5.15.61 PineCube is a low-powered, open source IP camera with the following specs: - Allwinner S3 Cortex-A7 - 128 MiB DDR3 - 16 MiB SPI flash - 5 MPx OV5640 camera - MicroSD slot - 10/100M Ethernet with passive PoE - 802.11 b/g/n WiFi - Bluetooth 4.1 - USB 2.0 - 26 pins GPIO header - Microphone - IR LEDs for night vision Board homepage: https://www.pine64.org/cube/ Board wiki: https://wiki.pine64.org/wiki/PineCube Signed-off-by: Jan Havran <havran.jan@email.cz> Reviewed-by: Giulio Benetti <giulio.benetti@benettiengineering.com> Signed-off-by: Thomas Petazzoni <thomas.petazzoni@bootlin.com>
32 lines
778 B
Plaintext
32 lines
778 B
Plaintext
Intro
|
|
=====
|
|
|
|
This directory contains a Buildroot configuration for building a
|
|
Pine64 PineCube.
|
|
|
|
Board homepage: https://www.pine64.org/cube/
|
|
Board wiki: https://wiki.pine64.org/wiki/PineCube
|
|
|
|
How to build it
|
|
===============
|
|
|
|
$ make pine64_pinecube_defconfig
|
|
$ make
|
|
|
|
Note: you will need access to the internet to download the required
|
|
sources.
|
|
|
|
How to write the SD card
|
|
========================
|
|
|
|
Once the build process is finished you will have an image called "sdcard.img"
|
|
in the output/images/ directory.
|
|
|
|
Copy the bootable "sdcard.img" onto an SD card with "dd":
|
|
|
|
$ sudo dd if=output/images/sdcard.img of=/dev/sdX
|
|
$ sudo sync
|
|
|
|
Insert the micro SDcard in your PineCube and power it up. The console
|
|
is on the serial port 2, 115200 8N1 (check Wiki for board pinout).
|