*******************************************************
Freescale i.MX6Q and i.MX6DL SABRESD development boards
*******************************************************
This file documents the Buildroot support for the Freescale SABRE Board for
Smart Devices Based on the i.MX 6 Series (SABRESD).
Read the SABRESD Quick Start Guide for an introduction to the board:
http://cache.freescale.com/files/32bit/doc/quick_start_guide/SABRESDB_IMX6_QSG.pdf
Build
=====
First, configure Buildroot for your SABRESD board.
For i.MX6Q:
make freescale_imx6qsabresd_defconfig
For i.MX6DL:
make freescale_imx6dlsabresd_defconfig
Build all components:
make
You will find in ./output/images/ the following files:
- imx6dl-sabresd.dtb or imx6q-sabresd.dtb
- rootfs.ext2
- rootfs.tar
- u-boot.imx
- uImage
Create a bootable SD card
=========================
To determine the device associated to the SD card have a look in the
/proc/partitions file:
cat /proc/partitions
Run the following script as root on your SD card. This will partition the card
and copy the bootloader, kernel, DTBs and root filesystem as needed.
*** WARNING! The script will destroy all the card content. Use with care! ***
./board/freescale/imx6sabresd/create-boot-sd.sh <your-sd-device>
Boot the SABRESD board
======================
To boot your newly created system (refer to the SABRESD Quick Start Guide for
guidance):
- insert the SD card in the SD3 slot of the board;
- locate the BOOT dip switches (SW6), set dips 2 and 7 to ON, all others to OFF;
- connect a Micro USB cable to Debug Port and connect using a terminal emulator
at 115200 bps, 8n1;
- power on the board.
Enjoy!
References
==========
https://community.freescale.com/docs/DOC-95015
https://community.freescale.com/docs/DOC-95017
https://community.freescale.com/docs/DOC-99218
7aff66f5b5