**************************
Freescale i.MX28 EVK board
**************************
This file documents the Buildroot support for the Freescale i.MX28 EVK board.
Read the i.MX28 Evaluation Kit Quick Start Guide [1] for an introduction to the
board.
Build
=====
First, configure Buildroot for your i.MX28 EVK board:
make freescale_imx28evk_defconfig
Build all components:
make
You will find in ./output/images/ the following files:
- imx28-evk.dtb
- rootfs.tar
- u-boot.sd
- zImage
Create a bootable SD card
=========================
To determine the device associated to the SD card have a look in the
/proc/partitions file:
cat /proc/partitions
Then, run the following command as root:
*** WARNING! The command will destroy all the card content. Use with care! ***
sudo dd if=output/images/sdcard.img of=/dev/<your-microsd-device>
Boot the i.MX28 EVK board
=========================
To boot your newly created system (refer to the i.MX28 EVK Quick Start Guide
[1] for guidance):
- insert the SD card in the SD Card Socket 0 of the board;
- verify that your i.MX28 EVK board jumpers and switches are set as mentioned
in the i.MX28 EVK Quick Start Guide [1];
- connect an RS232 UART cable to the Debug UART Port and connect using a
terminal emulator at 115200 bps, 8n1;
- power on the board.
Enjoy!
References
==========
[1] https://www.nxp.com/docs/en/user-guide/EVK_imx28_QuickStart.pdf
4e54522cae