kumquat-buildroot/board/visionfive2
Francois Dugast 704c62bbc5 configs/visionfive2_defconfig: new defconfig
Add a defconfig for the Starfive VisionFive2 board, a board built around the
Starfive JH7110 RISC-V 64bit SoC.

This board comes with functional lowlevel and U-Boot bootloaders in SPI
flash. The defconfig reuses these and only builds a (5.15 based) kernel and
rootfs.

The factory shipped U-Boot is hard coded to look at MMC partition 3.

Signed-off-by: Francois Dugast <francois.dugast.foss@gmail.com>
[Peter: add to DEVELOPERS]
Signed-off-by: Peter Korsgaard <peter@korsgaard.com>
2022-12-19 10:05:23 +01:00
..
overlay/boot/extlinux
genimage.cfg
readme.txt

Starfive VisionFive2
====================

The VisionFive2 is a low-cost RISC-V 64-bit based platform, powered by a
Starfive JH7110 processor.

How to build
============

$ make visionfive2_defconfig
$ make

How to write the SD card
========================

Once the build process is finished you will have an image called "sdcard.img"
in the output/images/ directory.

Copy the bootable "sdcard.img" onto an SD card with "dd":

  $ sudo dd if=output/images/sdcard.img of=/dev/sdX

Preparing the board
===================

Connect a TTL UART cable to pin 6 (GND), 8 (TX) and 10 (RX).

Insert your SD card.

Power-up the board using an USB-C cable.