kumquat-buildroot/board/boundarydevices/common/6x_upgrade.txt
Gary Bisson 85721034ae board/boundarydevices: rename folder and update readme
It didn't make sense to keep the U-Boot scripts and post build/image
scripts under the nitrogen6x folder since they apply for all our
platforms.

Also update the readme.txt to make it clearer which defconfig should
be used depending on the platform targeted.

Signed-off-by: Gary Bisson <gary.bisson@boundarydevices.com>
Signed-off-by: Peter Korsgaard <peter@korsgaard.com>
2016-03-03 17:42:14 +01:00

70 lines
1.5 KiB
Plaintext

if itest.s a$uboot_defconfig == a; then
echo "Please set uboot_defconfig to the appropriate value"
exit
fi
offset=0x400
a_uImage1=0x12000000
a_uImage2=0x12400000
if itest.s x6SX == "x${cpu}" || itest.s x7D == "x${cpu}"; then
a_uImage1=0x82000000
a_uImage2=0x82400000
fi
setenv stdout serial,vga
echo "check U-Boot" ;
if load ${dtype} ${disk}:1 ${a_uImage1} u-boot.$uboot_defconfig ; then
else
echo "No U-Boot image found on SD card" ;
exit
fi
echo "read $filesize bytes from SD card" ;
if sf probe || sf probe || sf probe 1 27000000 || sf probe 1 27000000 ; then
echo "probed SPI ROM" ;
else
echo "Error initializing EEPROM" ;
exit
fi ;
if sf read ${a_uImage2} $offset $filesize ; then
else
echo "Error reading boot loader from EEPROM" ;
exit
fi
if cmp.b ${a_uImage1} ${a_uImage2} $filesize ; then
echo "------- U-Boot versions match" ;
exit
fi
echo "Need U-Boot upgrade" ;
echo "Program in 5 seconds" ;
for n in 5 4 3 2 1 ; do
echo $n ;
sleep 1 ;
done
echo "erasing" ;
sf erase 0 0xC0000 ;
# two steps to prevent bricking
echo "programming" ;
setexpr a1 ${a_uImage1} + 0x400
setexpr o1 ${offset} + 0x400
setexpr s1 ${filesize} - 0x400
sf write ${a1} ${o1} ${s1} ;
sf write ${a_uImage1} $offset 0x400 ;
echo "verifying" ;
if sf read ${a_uImage2} $offset $filesize ; then
else
echo "Error re-reading EEPROM" ;
exit
fi
if cmp.b ${a_uImage1} ${a_uImage2} $filesize ; then
else
echo "Read verification error" ;
exit
fi
while echo "---- U-Boot upgraded. reset" ; do
sleep 120
done