From bf35bdac2adfa7c65c2992d8dedcc24585561732 Mon Sep 17 00:00:00 2001 From: Neal Frager Date: Wed, 13 Dec 2023 13:11:42 +0000 Subject: [PATCH] arm64: zynqmp: Add output-enable pins to SOMs Now that the zynqmp pinctrl driver supports the tri-state registers, make sure that the pins requiring output-enable are configured appropriately for SOMs. Without it, all tristate setting for MIOs, which are not related to SOM itself, are using default configuration which is not correct setting. It means SDs, USBs, ethernet, etc. are not working properly. In past it was fixed through calling tristate configuration via bootcmd: usb_init=mw 0xFF180208 2020 kv260_gem3=mw 0xFF18020C 0xFC0 && gpio toggle gpio@ff0a000038 && \ gpio toggle gpio@ff0a000038 Signed-off-by: Neal Frager Upstream: https://patchwork.ozlabs.org/project/uboot/patch/20231213134052.2818879-1-neal.frager@amd.com/ --- arch/arm/dts/zynqmp-sck-kd-g-revA.dts | 6 ++++++ 1 file changed, 6 insertions(+) diff --git a/arch/arm/dts/zynqmp-sck-kd-g-revA.dts b/arch/arm/dts/zynqmp-sck-kd-g-revA.dts index 56f3128528..12865392a3 100644 --- a/arch/arm/dts/zynqmp-sck-kd-g-revA.dts +++ b/arch/arm/dts/zynqmp-sck-kd-g-revA.dts @@ -175,6 +175,7 @@ conf-tx { pins = "MIO36"; bias-disable; + output-enable; }; mux { @@ -226,6 +227,7 @@ conf-bootstrap { pins = "MIO44", "MIO49"; bias-disable; + output-enable; low-power-disable; }; @@ -233,6 +235,7 @@ pins = "MIO38", "MIO39", "MIO40", "MIO41", "MIO42", "MIO43"; bias-disable; + output-enable; low-power-enable; }; @@ -241,6 +244,7 @@ slew-rate = ; power-source = ; bias-disable; + output-enable; }; mux-mdio { @@ -271,6 +275,7 @@ pins = "MIO54", "MIO56", "MIO57", "MIO58", "MIO59", "MIO60", "MIO61", "MIO62", "MIO63"; bias-disable; + output-enable; drive-strength = <4>; slew-rate = ; }; @@ -298,6 +303,7 @@ pins = "MIO66", "MIO68", "MIO69", "MIO70", "MIO71", "MIO72", "MIO73", "MIO74", "MIO75"; bias-disable; + output-enable; drive-strength = <4>; slew-rate = ; }; -- 2.25.1