kumquat-buildroot/board/intel/galileo/readme.txt

53 lines
1.2 KiB
Plaintext
Raw Normal View History

Intel Galileo Gen 1/2
Intro
============
These instructions apply to both the Intel Galileo Gen 1/2 development boards
based on the Intel Quark X1000.
How to build
============
Apply the defconfig for the Intel Galileo Gen 1/2
$ make galileo_defconfig
Add any additional packages required and build.
$ make
The build process will create a SD card image and place it in output/images.
$ ls -lh output/images/sdcard.img
-rw-r--r--. 1 foo foo 11M Nov 17 16:19 output/images/sdcard.img
Write the image to an mSD card, insert into the Galileo and power on.
$ dd if=output/images/sdcard.img of=/dev/mmcblk0; sync
Accessing the console
=====================
During power-on the console will become available on the Galileo's ttyS1. This
may be accessed as follows.
* Galileo Gen 1
http://clayskits.com/products/galileo-gen-1-serial-cable
A USB to RS-232 to 3.5mm Jack cable is required. Connect to the 3.5mm
Jack next to the Ethernet Header.
* Galileo Gen 2
http://www.ftdichip.com/Products/Cables/USBTTLSerial.htm
A FTDI TTL-232R-3V3 cable may be used to connect to the FTDI header
next to the Ethernet connector on the Galileo Gen 2.
The console should now be visible at 115200 baud.
$ picocom -b 115200 /dev/ttyUSB0