52 lines
1.2 KiB
Plaintext
52 lines
1.2 KiB
Plaintext
|
********************************
|
||
|
|
Xilinx ZCU106 board - ZynqMP SoC
|
||
|
|
********************************
|
||
|
|
|
||
|
|
This document describes the Buildroot support for the ZCU106 board by
|
||
|
|
Xilinx, based on the Zynq UltraScale+ MPSoC (aka ZynqMP). It has been
|
||
|
|
tested with the EK-U1-ZCU106-ES2 pre-production board.
|
||
|
|
|
||
|
|
How to build it
|
||
|
|
===============
|
||
|
|
|
||
|
|
Configure Buildroot:
|
||
|
|
|
||
|
|
$ make zynqmp_zcu106_defconfig
|
||
|
|
|
||
|
|
Compile everything and build the rootfs image:
|
||
|
|
|
||
|
|
$ make
|
||
|
|
|
||
|
|
Result of the build
|
||
|
|
-------------------
|
||
|
|
|
||
|
|
After building, you should get a tree like this:
|
||
|
|
|
||
|
|
output/images/
|
||
|
|
+-- atf-uboot.ub
|
||
|
|
+-- bl31.bin
|
||
|
|
+-- boot.bin
|
||
|
|
+-- boot.vfat
|
||
|
|
+-- Image
|
||
|
|
+-- rootfs.ext2
|
||
|
|
+-- rootfs.ext4 -> rootfs.ext2
|
||
|
|
+-- sdcard.img
|
||
|
|
+-- system.dtb -> zynqmp-zcu106-revA.dtb
|
||
|
|
+-- u-boot.bin
|
||
|
|
`-- zynqmp-zcu106-revA.dtb
|
||
|
|
|
||
|
|
How to write the SD card
|
||
|
|
========================
|
||
|
|
|
||
|
|
WARNING! This will destroy all the card content. Use with care!
|
||
|
|
|
||
|
|
The sdcard.img file is a complete bootable image ready to be written
|
||
|
|
on the boot medium. To install it, simply copy the image to an SD
|
||
|
|
card:
|
||
|
|
|
||
|
|
# dd if=output/images/sdcard.img of=/dev/sdX
|
||
|
|
|
||
|
|
Where 'sdX' is the device node of the SD.
|
||
|
|
|
||
|
|
Eject the SD card, insert it in the board, and power it up.
|